Wide Range Transmission Grip with Hot Latch
1649920
- Cable pulling grip securely pulls ACSR, AAC and bare copper cables
- Holds cable sizes from 0.68-Inch to 1.42-Inch (17.3 to 36.1 mm)
- Includes a latch to help maintain cable position in the grip jaw
- Fine tooth jaw geometry provides greater grip strength
- Made in the USA
- Innovative hot latch with V-notch centers cable
- Spring closes grip on cable to hold the initial position
- Large opening in the handle accommodates a wide variety of hooks on hoists, winches and tackle blocks
- Max Safe Load of 12000-Pound (5443 kg)
- Patent pending design
The Klein Tools Wide Range Transmission Grip with Hot Latch was specifically designed to securely pull ACSR, AAC and bare copper cables. Holds a wide range of cable from 0.68-Inch to 1.42-Inch (17.3 to 36.1 mm). This grip has a maximum safe load of 12,000-Pound.
Specifications
Type:
Parallel Jaw Grip
Application:
Wire Pulling
Special Features:
Hot Latch
Overall Length:
13.1 (33.3 cm)
Overall Height:
9.3'' (23.6)
Overall Width:
3.06'' (7.8 cm)
Material:
Steel
Cable Type:
ACSR, AAC and Bare Copper
Cable Diameter:
0.68'' to 1.42'' (17.3 to 36.1 mm)
Hot Latch:
Y
Swing Latch:
N
Spring:
Y
Locking Handle:
Y
Jaw Type:
Round
Jaw Length:
4.85'' (12.3 cm)
Maximum Safe Load:
12000 lb (5443 kg)
Weight:
8.3 lb (3.8 kg)
UPC:
092644470776
Warnings
- Grips are to be used for temporary installation, not for permanent anchorage.
- When used on/or near energized lines, ground, insulate, or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
